Posts

Showing posts from 2008


Setting GPRS All Operator GSM Indonesia

Setting GPRS All Operator GSM Indonesia

3 (Three)
Way of Activation :Active automatic at the time of registration and will be sent setting OTA as according to type of your handset.
Following setting manual :
GPRS/WAP
APN : 3gprs
username : 3gprs
password : 3gprs
IP address: 10.4.0.10
WAP homepage : http://wap.three.co.id/
HTTP port setting : 3128
MMS
APN : 3mms
username : 3mms
password : 3mms
mms gateway IP address: 10.4.0.10
MMS server address : http://mms.three.co.id/
HTTP port setting : 3128
So you connection to PC, Input of Extra Settings AT+CGDCONT=1,"IP","3gprs"

Telkomsel
Way Of Activation GPRS/MMS :
Halo Card
Enlist in GRAPARI or type sms "GPRS" sent to 6616 and "MMS" to 6616
SIMPATI
Type sms " GPRS " send to 6616 and "MMS" number code of behind simcard SIMPATI and send to 6616
Following setting manual :
GPRS/WAP
1. APN : telkomsel (wap), internet (general)
2. Username : wap
3. Password : wap123
4. WAP Gateway IP Address - 10.1.89.130
5. Port : 920…

Resetter Canon MP190/MP145/MP150/MP160

CANON MP190
Reset Waste Ink
1) Enter SERVICE MODE.By pressing Menu, Copy, Scan, Copy, Copy
2) Select TEST MODE.
3) Select [8] PRINTER TEST in TEST MODE.
4) Select 3. [EEPROM CLEAR].
5) Select 0. [INK COUNT].
6) Press the [Set] key.
7) Press the [Stop/Reset] key (returning to the state of 3), and then press the [ON/OFF] key.

CANON MP145
With the printer powered off but connected to a power source , you must:
A.Press stop/reset button, and then press [ON/OFF] button to restart
B.Press [ON/OFF] again and then press twice the stop/reset button.
C.Press [ON/OFF] & Stop/reset button together, this time to enter the repair status and power lights will be green.
D.Press stop/reset button 4x and warning lights will be go out in [ON/OFF]button.
E.Turn off the printer.( it must be turn off) and then turn it on again.

Use with your own risk , i'll try this way and my Pixma MP145 not blink again.
Read more after jump

CANON MP150
1) With the printer powered off but connected to a power source, press the Power…